durofix-rukovodstvo-po-ispolzovaniyu-durofix-app-dlya-dr002
Durofix
M A N U F A C T U R E R S O F P R E C I S I O N & P O W E R
Q U A L I T Y • D U R A B I L I T Y • R E L I A B I L I T Y • V A L U E
DATA COMM
DESIGNED FOR VERSATILITY
DR002
Tune-up your torque settings (operation cycle & rotation, screw runtime) for more precise applications
Memorize your own torque settings pattern
Real-Time monitoring for up to 10 tools at jobsite
Collect all fastening data in assembly process
Durofix
App Feature: Tools setting
1. Change Tools Identity into workstations needs
2. Change Tools Cycle Counting 3. Enable counting 1,2,3,… 4. Enable to Counting back from 1,2,3,… 5. Enable to use Stack Light
7. Enable Buzzer Sound
6. First Fastening NG for cross threading
Durofix
App Feature: Tools setting
8. Adjust Speed
10. Change up to 8 pre-set Program
9. Reduce Reaction Force
For SJ – Normal - HJ
11. Soft-Start settings: Start Slower for a pre-set time 12. Correction / Calibration: adjusting tools to follow Torque tester or Torque Wrench value
Favorite
Program
All this feature pre-set will be saved within selected Favorite Program:
Durofix
App Feature: Tightening Strategies
1. Times setting: determining OK/NG by time. 2. Turns setting: determining OK/NG by how many turns.
Tightening Strategies: - Able to combine this 5 feature at the same time.
3. Torque setting: determining OK/NG by Torque Value. 4. Angle setting: determining OK/NG by Angle Degree.
5. Multiple Speed / Shift Down Setting : When Torque reaching pre-set value, The Speed will Reduce to pre-set RPM *mainly for Plastic Joint Application*
Tool Monitor Mode
DR002 able to connect up to 10 tools
Tools Monitor Mode
1. Unit Type able to change and show into: Times, Turns, Torques, Angles
Note: Data will be automatically exported into “.CSV Files” after 1000 tightening, indicated in “ID”
Durofix
App Parameters
Parameters
Computing CMK Results
1. Setting Upper and Lower Limit
2. Adding the data to Compute Results
Results
Non
-
Transducer Parameters setting
Note: Only “OK/NG” data For RV2047, RV2048, RV2017/27/37, RZ4012, and RZ4014 since the tools does not have any transducer to sense torque and angle value.
Tools Monitor Mode
THANK YOU
